Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Foldaway Workbench
#1
Hello,

I'd like to share a workbench build that I did for my garage, the only two requirements was: low cost and that it should not take up any space as I have 2 cars parking in a 2 car garage. 

After much YouTube and googling I found a design that I really liked by Craig English (Fold up Workbench)

Step 1 (The table top):
    21mm Plywood and roof truss pine  (114mmx38mm) frame

   
   

Step 2 (Legs):
     50mmx76mm roof truss pine, doubled at the bottom for wheel mounting
   
   
   
   

Step 3 (Stop/Lock):
     A simple rounded piece of 114x38 pine used to create a rotating stop.
   

Done:
   
   
   

Wall Mounted:
   

Hope you found this useful... Throw any comments downs below.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)